Internal Microphone Failure - Packard Bell EasyNote LJ61 Service Manual

Internal Microphone Failure

If the internal Microphone fails, perform the following actions one at a time to correct the problem. Do not
replace a non-defective FRUs:
Microphone Problems
If internal or external Microphones do no operate correctly, perform the following actions one at a time to
correct the problem.
1. Check that the microphone is enabled. Navigate to Start
Sound and select the Recording tab.
2. Right-click on the Recording tab and select Show Disabled Devices (clear by default).
3. The microphone appears on the Recording tab.
4. Right-click on the microphone and select Enable.
5. Select the microphone then click Properties. Select the Levels tab.
6. Increase the volume to the maximum setting and click OK.
7. Test the microphone hardware:
a. Select the microphone and click Configure.
b. Select Set up microphone.
c. Select the microphone type from the list and click Next.
d. Follow the onscreen prompts to complete the test.
8. If the Issue is still not resolved, see "Online Support Information" on page 187.
140
S tart S tart
OK OK
Check M/B Check M/B
NG NG
Mic cable Mic cable
OK OK
OK OK
Check MIC Check MIC
NG NG
wire of LCD wire of LCD
module module
S wap M/B S wap M/B
Re-asse mble Re-asse mble
the MIC cable the MIC cable
to M/B to M/B
S wap MIC wire S wap MIC wire
of LCD module of LCD module
[
Control Panel Hardware and Sound
Chapter 4