Replacing The Lcd Module - Packard Bell EasyNote LJ61 Service Manual

Replacing the LCD Module

1. Turn the computer over. Align the LCD hinges with the lower cover and replace the LCD module.
2. Replace the four securing screws (two each side), starting with the left side hinge. Ensure that the LCD
cables are not trapped in the hinges.
NOTE: The securing screws differ in size: Red callout—M2.5*8, Green callout—M2.5*5.
3. Run the MIC cable along the cable channel as
shown, using all the available cable clips.
120
4. Reconnect the MIC cable to the Mainboard as
shown.
Chapter 3