Sharp BD-HP90RU Operation Manual page 52

Hide thumbs Also See for BD-HP90RU:
Table of Contents

Advertisement

Troubleshooting
Picture
Problem
No picture.
Screen freezes and operation
buttons do not work.
Widescreen video appears vertically
stretched, or black bands appear at
the top and bottom of the screen.
Square noise (mosaic) appears on
the screen.
Audio is not output, or images are
not played back properly.
3D images cannot be output to a TV.
Noise appears on the screen.
Sound
Problem
No sound, or sound is distorted.
Audio is not output, or images are
not played back properly.
50
Make sure that the cables are connected correctly. (Page 19)
Make sure that the connected TV or the AV receiver is set to the correct input.
(Page 19)
Take out the disc and clean it. (Page 12)
Make sure that region code on the disc matches that of this Player. (Page 8)
There is no picture from the HDMI output.
Are the settings performed correctly? Please check the settings. (Page 40)
Turn off the power and turn on the power again.
If the power is not turned off, perform a reset. (Page 51)
Is the disc damaged or dirty? Check the condition of the disc. (Page 12)
Is "TV Aspect Ratio" set to match the connected TV? (Page 40)
If you are using a widescreen TV, is the "TV Aspect Ratio" set to "Wide"? (Page 40)
Blocks in images may be visible in scenes with rapid movement due to the
characteristics of digital image compression technology.
The audio may not be output or the images may not be played back properly for
some discs in which copyright-protected contents are recorded.
Is an HDMI cable used?
Are a 3D compatible TV and 3D glasses used?
Is a proper connection made between the HDMI OUT terminal of the player and the
HDMI input terminal of the 3D compatible TV?
Is the 3D setting on this player correct? (Pages 25, 42)
Is the 3D setting on the TV correct?
Is a 3D compatible BD disc being played back?
When you watch TV broadcasts with the power of this player turned on, noise may
appear on the TV screen. In such cases, turn off the power to this player or keep
this player away from the TV.
If the volume of the TV or amplifier is set to minimum, turn the volume up.
There is no sound during still mode, slow motion playback, fast forward and fast
reverse. (Page 34)
Check that the audio cable is connected correctly. (Page 20)
Check that the cable plugs are clean.
Take out the disc and clean it. (Page 12)
Audio may not be output depending on the audio recording status, such as when
audio other than an audio signal or non-standard audio is recorded for the audio
content of the disc. (Page 8)
The audio may not be output or the images may not be played back properly for
some discs in which copyright-protected contents are recorded.
Possible causes and solutions
Possible causes and solutions

Advertisement

Table of Contents
loading

Table of Contents