Clock; Turn Atomic Clock On/Off; Set Clock; Switch Clock Display - Oregon Scientific RMR612HGA User Manual

CLOCK

This product shows the current time, time zone, and day
of week in English, Spanish, or French. The time is
automatically updated by the US Atomic Clock in
Boulder, Colorado unless you disable this feature.
Signals are collected by the main unit when it is within
1500 km (932 miles) of a signal.
Initial reception takes 2 - 10 minutes, and is initiated
when you first setup the unit, and whenever you press
RESET. Once complete, the reception icon will stop
blinking. The icon is shown in the Clock Area.
To force a manual search for Atomic Clock signals, press
and hold UP for 2 seconds. If no signal is found, check
the batteries.

TURN ATOMIC CLOCK ON/OFF

Perform this step if you cannot receive Atomic Clock
signals. Press and hold ZONE (located in the battery
compartment) for 2 seconds. Then, manually set the
clock following the "Set Clock" instructions (below).
The signal icon indicates that the Atomic Clock
feature is ON. No icon means that it is OFF.
RMR612HGA lab test R2

SET CLOCK

You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1. Open the battery compartment.
2. Press ZONE repeatedly to display the desired Time
Zone: (P) Pacific, (M) Mountain, (C) Central, or
(E) Eastern.
3. Close the battery compartment.
4. Press and hold MODE for 2 seconds. The Clock
Area will blink.
5. Select the hour, minute, year, month, day, and
language. Press UP or DOWN to change the
setting. Press MODE to confirm.
NOTE
(F) French, and (S) Spanish.

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.
8
8
The language options are (E) English,
1/17/04, 4:58 PM