Download Print this page

Craftsman 875.199510 Owner's Manual page 3

Pneumatic 1/4" angle die grinder
Hide thumbs

Advertisement

::O
Branch line = 2 times
Tool inlet/hose size
Auto Drain
Va Ive
_Auto
Drain
Va Ive
More than 1/100 slope
Stop
Valve
Filter
Regulator
Lubricator
Air Tool
Figure 1
Air Hose Hook Up
Main line = 3 times
Tool inlet/hose
size
To change the grinding stones:
Always disconnect the tool from the air supply before
changing
accessories
Loosen the collet nut with the wrenches supplied
(Figure 2)
Insert the grinding stone in the collet. If using a 1/8-
in. collet stone an adapter must be inserted before
placing the stone into the tool.
Tighten collet nut with the two wrenches supplied
Figure 2
Figure 3
Lubrication
An in-line filter-regulator-lubricator
(fig 1) is recommended
as it increases tool life and keeps the tool in sustained
operation. The in-line lubricator should be regularly
checked and filled with air tool oil. Proper adjustment of
the in-line lubricator is performed by placing a sheet of
paper next to the tools exhaust ports and holding the
throttle open approximately 30 seconds. The lubricator is
properly set when a light stain of oil collects on the paper.
Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for
an extended period of time (overnight, weekend, etc.), it
should receive a generous amount of lubrication through
the air inlet. The tool should be run for approximately 30
seconds to ensure oil has been evenly distributed through
out the tool. The tool should be stored in a clean dry
environment.
Recommended
lubricants:
Use air tool oil or any other
high grade turbine oil containing moisture absorbent, rust
inhibitors, metal wetting agents and an EP (extreme
pressure) additive.
[, WARNINel
Always
make sure that tool accessories
meet or
exceed the tools recommended
output.

Advertisement

loading

  Related Manuals for Craftsman 875.199510