Download Print this page

Craftsman 315.101300 Owner's Manual page 9

3/8 in. drill-driver variable speed / reversible double insulated

Advertisement

,_,
WARNING:
Make sure to insert drill bit straight
into chuck jaws. Do not insert drill bit into chuck
jaws at an angle and then tighten, as shown in
Figure 5. This could cause drill bit to be thrown
from drill, resulting in possible serious personal
injury or damage to the chuck.
Fig. 5
REMOVING
BITS
See Figure 4.
Unplug your drill.
,_lh WARNING:
Failure to unplug your drill could
result in accidental starting causing serious
injury.
Loosen the chuck jaws from drill bit.
To loosen: grasp and hold the collar of the chuck
with one hand, while rotating chuck body with your
other hand.
Note: Rotate chuck body in the direction of the
arrow marked UNLOCK to loosen chuck jaws.
Do not use a wrench to tighten or loosen the
chuck jaws.
Remove drill bit from chuck jaws.
ADJUSTABLE
TORQUE
CLUTCH
Your drill is equipped with an adjustable torque clutch
for driving different types of screws into different
materials. The proper setting depends on the type of
material and the size of screw you are using.
TO ADJUST
TORQUE
Identify the twenty four torque indicator settings
located on the front of your drill. See Figure 6.
Rotate adjusting ring to the desired setting.
1 - 4
For driving small screws.
5 - 8
For driving screws into soft
material.
9 - 12
For driving screws into soft and
hard materials.
• 13 - 16
For driving screws in hard wood.
• 17 - 20
For driving large screws.
• 21 - ,l_l
For heavy drilling.
TO DECREASE
ADJUSTING
TORQUE
RING
TO INCREASE
TORQUE
Fig. 6
9

Advertisement

loading