Download Print this page

Operation; Flat Washer; Nylon Washer - Craftsman 486.245042 Operator's Manual

6.5 h.p. soft top vac system and cart
Hide thumbs

Advertisement

Assemble t headapter b racket t othedeckusing two
5/16"x 1-1/4" hexbolts,5/16" flatwashers and5/16"
nylock nuts. S eefigure 25.
NOTE:It maybenecessary t o useextra5/16"flat
washers toshimunder thebracket n exttothedeck
surface. T enextrawashers havebeenfurnished as
shims.Seefigure25.
(2) 5/16" NYLOCK
5/16" FLAT
WASHERS
FIGURE 25
With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9/32" diameter holes in the
top of the deck adapter. See figure 26.
Bolt deck adapter to bracket using three 1/4" x 1"
bolts, nylon washers, 1/4" fiat washers and 1/4"
nylock nuts. Ny!on washers should be against the
inside of the deck adapter. See figure 26.
DECK
ADAPTER
(3) 1/4" NYLOCK
NUTS
J
ADAPTER
-
BRACKET
(3) NYLON
_
MOWER DECK
WASHERS
(3) 1/4" STEEL WASHERS
(3) 1/4" x 1" HEX BOLTS
FOR 1990 AND NEWER
MURRAY
TRACTORS
WITH A 38" OR 40" DECK
Cut out two templates and place on deck adapter
as shown in figure 33. Tape smaller one on top and
larger one on the side and bottom= After they are in
place, carefully mark around the templates, then cut
out adapter to obtain correct opening.
Bolt end of mounting strap to the 5/16" bolt on the
mower deck=The other end of the strap will bolt to
a hole in the deck adapter, which must be drilled.
Position the adapter on the deck, then drill a 5/16"
hole in the bottom of the adapter that will align with
the hole in the strap= Fasten the adapter to the strap
using one 1/4" x 1" hex bolt, 1/4" flat washer, nylon
washer and 1/4" nylock nut. See figure 27.
38"/40" TEMPLATE
TEMPLATE
TO CUT OUT SLOT
CUT OUT SLOT IN TOP
OF DECK ADAPTER
1t4" × 1" HEX BOLT
1/4" FLAT WASHER
BOLT THBS END OF
STRAP TO 5/16" BOLT
ON MOWER DECK
I
NYLON WASHER
MOUNTmNG
STRAP
1/4" NYLOCK NUT
FIGURE 27
Assemble end of hose and hose clamp over the
round opening of deck adapter and tighten clamp.
GO DIRECTLYTOTNE
OPERATION INSTRUCTIONS
WHICH ARE LOCATED ON PAGE 18.
FIGURE 26
,
Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp.
GO DJRECTLYTOTNE OPERATION INSTRUCTIONS
ON PAGE 18.
16

Advertisement

loading

  Related Manuals for Craftsman 486.245042