Download Print this page

Craftsman 486.245042 Operator's Manual page 12

6.5 h.p. soft top vac system and cart
Hide thumbs

Advertisement

Place the support tubes down into the front and
rear tube support brackets, with the tube's welded
brackets facing the center of the cart,
Assemble the top connecting tubes to the support
tubes using four 1/4" x 1ol/4" hex bolts and 1/4"
nylock nuts, Tighten unti! the end of the bolt extends
through the nut, See Figure 12,
114"× 1-1/4"
HEX BOLT
1/4" NYLOCK NUT
/
TuBEOONNEOT'NG
FIGURE 12
To install the fabric cart cover:
1, Unzip the cover's rear flap and place cover on top
of the support tubes, making sure that the zippered
flap is at rear of cart,
2, Pull the front of the cover down over the front
support tubes and hook the cover's plastic channel
under the cart's front flange,
3, Pul! the sides of the cover down and hook the
cover's plastic channel
under the cart's side
flanges,
4, Swing the rear flap up onto the top of the cover,
Starting at the top, secure the cover to the rear
support tubes with the three vetcro straps on
each side, Tighten the straps so that the zipper is
pulled around behind the support tubes, The zipper
should close easily,
5, Unzip the rear flap to place the tailgate down into
the tailgate guides, See Figure 13,
Cover
FIGURE 13
12

Advertisement

loading

  Related Manuals for Craftsman 486.245042