Table of Contents
Advertisement
PRODUCT
SPECIFICATIONS
SERIAL
NUMBER
DATE OF PURCHASE
GASOLINE
CAPACITY/TYPE:
UNLEADED
REGULAR
OIL TYPE (API-SF/SG/SH):
OIL CAPACITY:
SPARK PLUG (GAP:
.030")
VALVE
CLEARANCE:
SOLID STATE IGNITION
AIR GAP:
=
BLADE BOLT TORQUE:
1.6 QUARTS
SAE30(ABOVE32°F)
SAE 5W-30
(BELOW
32°F)
20 OZS.
CHAMPION
RJ19LM OR Jt9LM
INTAKE:
.005 - .007
EXHAUST:
.007 - .009
.010 IN,
35-40 FT. LBS.
• The model
and serial numbers
will be found on e decal attached
to the rear of the
lawn mower
housing.Record
both serial
number
and date of purchase in space
provided
above.
LAWN MOWER
Always
observe safety rules when
performing
any maintenance.
TIRES
• Keep tires free of gasoline, oil, or insect
control chemicals which can harm
rubber,
• Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may
cause tire damage.
BLADE
CARE
For best results, mower blade must be
kept sharp.
Replace bent or damaged
blades.
TO REMOVE
BLADE
• Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact with spark plug.
• Turn lawn mower on its side.
Make
sure air filter and carburetor
are up.
• Use a wood block between
blade and
mower housing to prevent blade from
tuming when removing blade bolt.
• Protect your hands with gloves and/or
wrap blade with heavy cloth.
• Remove blade bolt by turning counter-
clockwise.
• Remove
blade
and attaching hardware
(bolt, lock washer and hardened
washer).
NOTE:
Remove
the blade adapter and
check the key inside hub of blade
adapter.
The key must be in good
condition
to work properly.
Replace
adapter
if damaged.
11
TO REPLACE
BLADE
• Position the blade adapter
on the
engine crankshaft.
Be sure key in
adapter and crankshaft
keyway
are
aligned.
• Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
• Be sure the trailing edge of blade
(opposite sharp edge) is up toward the
engine.
• Install the blade bolt with the lock
washer and hardened
washer into
blade adapter
and crankshaft.
• Use block of wood between
blade and
lawn mower
housing
and tighten the
blade bolt, turning
clockwise.
• The recommended
tightening
torque
is
35-40 ft. Ibs.
Advertisement
Table of Contents
