Table of Contents
Advertisement
[] Afternormal u sage, a minimum of 1 hourofcharging
timeis required t o fullyrecharge b attery pack.
[] Thebattery packwill become slightly warmto the
touchwhilecharging. Thisis normal a nddoesnot
indicate a problem.
[] Donot place thecharger a ndbattery packin anarea
of extreme heator cold.Theywillworkbestat normal
roomtemperature.
NOTE: Thecharger a ndbattery packshouldbeplaced
ina location where thetemperature i s morethan50°F
butlessthan100°R
[] Whenbatteries become fullycharged, unplug the
charger f rompowersupply andremove thebattery
pack.
CHARGING
A HOT BATTERY
PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately
30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears or
other qualified service center for checking or replacing.
NOTE: This situation only occurs when continuous use
of the tool causes the batteries to become hot. It does
not occur under normal circumstances.
Refer to CHARG-
iNG A COOL BATTERY PACK for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances,
return both the battery
pack and charger to your nearest Sears or other qualified
service center for electrical check.
TO INSTALL
BATTERY
PACK
See Figure 3.
[] Lock the switch trigger by placing the direction of rota-
tion selector in the center position.
[] Place battery pack in the tool. Align raised rib on
battery pack with groove inside tool. Make sure the
latches on each side of the battery pack snap into
place and battery pack is secured in tool before begin-
ning operation.
CAUTION:
When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
groove inside tool and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 3
TO REMOVE
BATTERY
PACK
See Figure 3.
[] Lock switch trigger on the tool by placing the direction
of rotation selector in center position.
[] Locate latches on end of battery pack and depress to
release battery pack from the tool.
[] Remove battery pack from the tool.
11
Advertisement
Table of Contents
