Download  Print this page

Operation - Craftsman 315.115460 Operator's Manual

14.4 volt impact driver variable speed/reversible
Hide thumbs

Advertisement

A
WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
A
WARNING:
Do not use any attachments
or acces-
sories not recommended
by the manufacturer of
this tool. The use of attachments
or accessories not
recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
[] Driving long deck screws while building a deck
[] Driving carriage bolts into deck posts
[] Driving Tapcon screws into block walls and concrete
[] Driving screws into metal studs
[] Driving nuts and bolts using an impact socket
CAUTION:
If at any point during the charging
process none of the LEDs are lit, remove the bat-
tery pack from the charger to avoid damaging the
product. DO NOT insert another battery. Return the
charger and battery to your nearest Sears or other
qualified service center for service or replacement.
LED FUNCTIONS
OF CHARGER
LED WILL
BE ON TO INDICATE
STATUS
OF
CHARGER
AND BATTERY
PACK:
[] Red LED on = Fast charging mode.
[] Green LED on = Fully charged and in maintenance
charge mode.
[] Green LED on = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of normal temperature
range.
[] Yellow and Green LEDs on = Deeply discharged or
defective battery pack.
[] No LED on = Defective charger or battery pack.
CHARGING
THE BATTERY
PACK
The battery pack for this tool has been shipped
in a low
charge condition to prevent possible problems. Therefore,
you should charge it until the green LED on the front of the
charger comes on.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
10
CHARGING
A COOL
BATTERY
PACK
If battery pack is below normal temperature range, the green
LED on charger will come on. Allow battery pack to reach
normal temperature, then the red LED will come on.
NOTE: If the charger does not charge the battery pack under
normal circumstances, return both the battery pack and char-
ger to your nearest Sears or other qualified service center for
electrical check.
[] Charge the battery pack only with the charger provided.
[] Make sure the power supply is normal household
voltage, 120 vo(ts, 60 Hz, AC only.
[] Connect the charger to the power supply.
[] Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger. See
Figure 2.
[] Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
[] Normally the red LED on charger will come on. This
indicates the charger is in fast charging mode.
[] Red LED should remain on for approximately
1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is
in maintenance charge mode.
NOTE: The green LED will remain on until the battery
pack is removed from the charger or charger is
disconnected
from the power supply.
[] If both yellow and green LEDs come on, this indicates
a deeply discharged or defective battery pack. Allow
the battery pack to remain in the charger for 15 to 30
minutes. When the battery pack reaches normal
voltage range, the red LED should come on. If the red
LED does not come on after 30 minutes, this may
indicate a defective battery pack that should be
replaced.
BATTERY PACKIN
CHARGER
LEO
GREEN LED
Y
CHARGER
Fig. 2

Advertisement

loading

  Related Manuals for Craftsman 315.115460