Page 21
T.estNumber 13--Dwell Adjustment--Breaker Point S#s##m.s
1.
Rotate the Function Selector Switch to the dwell position.
2.
Consult your vehicle service manual to determine which vacuum hoses,
if any, should be disconnected and plugged prior to making dwell ad-
justment or test.
3.
Run the engine at specified idle speed and note dwell reading on proper
4-6 or 8-cylinder scale to correspond to the engine under test.
4.
Compare results to vehicle specifications_ adjust _o correct dwell
if required.
READ PROPERSCALE TO SUIT
NUMBER OF ENGINE
CYLINDERS
BLACK
RED J
CLIP
CLIP
_J
BAT,+
COIL
_
FIGURE 22
DWELL ADJUSTMENT CONNECTIONS
GREEN
CLIP
DIST.
DISTRIBUTOR
On engines that have a sliding window in the distributor cap, adjust dwell
as follows:
I.
Operate
engine
at specified
idle.
2.
Raise the window
and insert a I/8" Allen wrench
into the adjustment
screw.
3.
Turn the adjustment
screw until the correct dwell
is indicated on the
dwell scale.