Craftsman 973.111400 Owner's Manual page 8

SWITCH
See Figure 2,
To turn your drill ON, depress the switch trigger. To
turn it OFF. release the switch trigger.
SWTCHJ
TRIGGER
_SELECTOR
Fig. 2
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned, this is a
normal part of the switch function, ?,
TWO-SPEED GEAR TRAIN
See Figure 3.
Your drill has a two-speed gear traln designed for
drilling or driving at H! or LO speeds. A slide switch is
located on top of your drill to select either HI or LO
speed. When using drill in the HI speed range, speed
w{[I increase and unit will have less power and torque.
When using drill ]n the LO speed range, speed will
decrease and unit will have more power and torque.
Use HI speed for fast drilling or driving applications
and LO speed for high power and torque applications.
HISPEED
LO SPEED TWO SPEED
GEAR TRAIN(HI-LO)
TO INSTALL BATTERY PACK
• Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 5.
• Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack.
See Figure 4.
BA'n'ERYPACK
LATCHES
DEPRESS LATCHES TO
RELEASE BA'i-rERY PACK
Fig 4
• Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in
drill before beginning operation,
_1= CAUTION; When p[acing battery pack in your
drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap into
place properly. Improper assembly of battery
pack can cause damage to internal components
TO REMOVE BATTERY PACK
• Lock switch trigger on your drill by placing the
direction of rotation selector in center position
See Figure 5.
• Locate latches on end of battery pack and depress
to release battery pack from your drill
See Figure 4.
• Remove battery pack from your drill.