Advertisement
PRODUCT
SPECIFICATIONS
SERIALNUMBER
DATE OF PURCHASE
GASOLINE
CAPACITY/TYPE:
OIL TYPE (API-SF/SG/SH):
OIL CAPACITY:
SPARK PLUG (GAP:
.030")
VALVE CLEARANCE:
SOLID STATE IGNITION
AIR GAP:
BLADE BOLT TORQUE:
1.5 QUARTS
UNLEADED
REGULAR
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
20 OZS.
CHAMPION
RJ19LM OR J19LM
INTAKE:
.004 - .008
EXHAUST:
.004 - .008
.0125 IN.
35-40 FT. LBS.
• The model and serial numbers will be found on a decal attached
to the rear of the
lawn mower housing.Record both serial number and date of purchase in space
provided above.
LAWN MOWER
Always observe safety rules when performing
any maintenance.
TIRES
• Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be
kept sharp.
Replace bent or damaged
blades.
TO REMOVE BLADE
• Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
• Turn lawn mower on its side.
Make
sure air filter and carburetor
are up.
• Use a wood block between
blade and
mower housing to prevent blade from
turning when removing
blade bolt.
• Protect your hands with gloves and/or
wrap blade with heavy cloth.
• Remove blade bolt by turning counter-
clockwise.
• Remove
blade and attaching
hardware
(bolt, lock washer
and hardened
washer).
NOTE:
Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly. Replace adapter if damaged.
TO REPLACE
BLADE
• Position the blade adapter on the
engine crankshaft.
Be sure key in
adapter and crankshaft
keyway are
aligned.
• Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter.
• Be sure the trailing edge of blade
(opposite
sharp edge) is up toward the
engine.
• Install the blade bolt with the lock
washer
and hardened
washer
into
blade adapter and crankshaft.
• Use block of wood between blade and
lawn mower housing
and tighten the
blade bolt, turning clockwise.
• The recommended
tightening
torque is
35-40 ft. Ibs.
11
Advertisement
