GE PFSS6SMXASS Owner's Manual And Installation Instructions page 29

Installation Instructions
[] REPLACING THE REFRIGERATOR DOORS
(cont.)
[] Insert the top hinge pin into the hinge hole on top
of the refrigerator door. Make sure the door is aligned
with the cabinet and opposite door.Attach the hinge
to the top of the cabinet. Do not tighten bolts
completelg.
[] On left-hand doors, pass the wires and water line
through the top hinge pin.Then connect the water line
and two connectors.
i
i
i
r_ Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
[] Make sure the gasket on the door is flush against
the cabinet and is not folded. Make sure the door is
straight and the gap between the doors iseven across
the front. While holding the aligned door in place,
tighten the top hinge bolts.
rill Reconnectthe two connectors at each side of the top
cap and reattach the three Phillips-headscrews on top.
\
171REMOVE THE FREEZER DOOR
_'1 Pullthe freezer door open to full extension.
Removethe freezer bin bg pulling both brackets upward
at the same time. (Seepage 19.)
Fc1 Take out the lower basket bg lifting the basket up from
the rail sgstem.(Seepage 19.)
Removethe two 10 mm hex-head bolts from the right
and left side.
29