GE PFSS6SMXASS Owner's Manual And Installation Instructions page 24

Installation
Instructions
Refrigerator
Profile Model 26
Questions? Cell 800.GE.CARES (800.432.2737) or Visit our Website et: ge.com
In Cenede, cell 1.800.561.3344 or Visit our Website et: www.geeppliences.ce
BEFORE YOU BEGIN
Reed these instructions completely end carefully.
• IMPORTANT - Save these instructions for l ocal
inspector's use.
•
IMPORTANT
-Observe all g overning codesand
ordinances.
• NotetoInstaller- Be sure toleave t hese instructions with
theConsumer.
• Note to Consumer- Keepthese instructions for future
reference.
• Skill level- Installation of this appliance requiresbasic
mechanical skills.
• Completion time- Refrigerator Installation 20 minutes
Water Line Installation 30 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through o doorwey,
the refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door,see the Installing
the Rdrigerotor section.
• To remove the freezer drawer, see the Removing
the FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.A GEwater supply kit
(containing tubing, shutoff valve, fittings and instructions)
is available atextra cost from your dealer,by visiting our
Website at ge.com (in Canada at www.geappliences.ca)
or from Parts and Accessories,800.626.2002(InCanada
1.888.261.3055).
TOOLS YOU MAY NEED
10mm SocketRatchet/Driver
AdjustableWrench
1/4" OuterDiameter
Compression N ut
andFerrule(sleeve)
Phillips-Head Screwdriver
3/32", 1/8" and4 mm
Allen Wrenches
1/8" Drill Bit and
Electricor HandDrill
................ };}'T)
Pencil
Pliers
Flat-Head Screwdriver
Tape Measure
1/4" Nut Driver
Level
24