Craftsman 320.16494 Operator's Manual page 43

Mounting Non=Standard
Miter Saws
NOTICE: This configuration
allows for miter saws on which
the 4 mounting holes hole form
a trapezoid pattern (some saws)
and the those on which the 3
mounting holes form a triangular
pattern (few saws).
1. Place the two support bars
(B) on the mounting brackets
(A). Use the support bar
mounting bolts (E), washers
(F), spring washers (G) and
locking nuts (H) to pre-tighten
the support bars (B) on the
quick-release mounting
brackets (A) (Figs. 6 and 7).
2. Position your miter saw with
non-standard mounting holes
on the cross support bars (B).
Check the position and adjust
the support bars slowly so
that the mounting holes on
the miter saw are aligned with
the slots on the cross support
bars (Fig. 8).
3. Use the miter saw mounting
bolts (C), washers (D), spring
washers (G) and locking nuts
(H) to securely tighten the
saw to the support bars (B).
4. Tighten the locking nuts (H)
to fully tighten the support
bars (B).
Fig. 6
E
Fig. 7
A
B
Two support bars (B) installed on
mounting brackets (A)
\
G
Page 12 16494 ManuaLRevised_12 0522