Table of Contents
Advertisement
Available languages
Available languages
Using
the
Wall.Mounted
Door
Control
THE PREMIUM CONTROL CONSOLE
Press the lighted push
button to open or close the
door. Press again to
reverse the door during the
closing cycle or to stop the
door while it's opening.
LIGHTED
PUSH BUTTON
HT BUTTON
LOCK BUTTON
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button
until the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes.
Repeat the procedure and the light will blink twice,
resetting the timer to 2-1/2 minutes. Repeat again for
a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key
Switch and the Keytess Entry Accessories.
To activate, press and hold the Lock button for two
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
two seconds.The
push button light will stop flashing.
The Lock feature will also turn off whenever the
Learn button on the motor unit panel is activated.
Additional feature when used with the 3-function
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the Premium
Control Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.
To Open
the
Door
Manually
• To prevent possible SERIOUSINJURY or DEATHfrom
a falling garage door:
- If possible, use emergency releasehandle to
disengagetrolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency release handle unless garage
doorway is clear of personsand obstructions.
• NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually. The
lockout feature prevents the
trolley from reconnecting
_Trolley
\
Trolley
Release Arm
(in ManuaI
Disconnect
Position)
Lockout position
automatically, and the door can (Manual disconnect)
be raised and lowered manually
as often as necessary.
TO RE-CONNECT THE
TROLLEY:
Pull the emergency release
handle toward the opener at a
45 ° degree angle so that the
trolley release arm is horizontal.
The trolley will reconnect on the
next UP or DOWN operation,
either manually or by using the
door control or remote.
Trolley
__Trolley
Release
Emergency
Arm
Release
(Pull at 45 ° angle)
To reconnect
Page 32
- Quick Links:
- Having a Problem
- Programming
- Repair Parts
Hide quick links:
Advertisement
Chapters
Table of Contents
