Troubleshooting Guide - Euro-Pro ULTRA SHARK EP366 Use And Care Instructions Manual

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE REASON
1. Power cord not firmly
plugged into outlet.
HAND VACUUM WILL
NOT OPERATE 2. No power in wall outlet.
3. Needs servicing.
HAND VACUUM WILL 1. Dust cup filter is full.
NOT PICK-UP OR 2. Unit clogged.
SUCTION POWER IS 3. Dust cup filter needs
WEAK cleaning.
1. Dust cup filter is full.
DUST ESCAPING 2. Dust cup filter is not
FROM HAND installed correctly.
VACUUM 3. Puncture/hole in dust cup
filter.
HAND VACUUM HOSE
1. Hose clogged.
OR BRUSHES WILL
2. Dust cup filter is full.
NOT PICK-UP
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
3. Call 1 (800) 798-7398.
1. Empty dust cup filter –
(see page 4).
2. Turn unit off and unplug
from wall outlet. Remove
dust cup filter and check
for object(s) in air duct
and remove.
3. Clean or replace dust cup
filter. (see page 4).
1. Empty dust cup filter.
2. Review dust cup filter
instructions. (see page 4)
3. Replace dust cup filter.
(see page 4)
1. Remove hose and/or
bushes. Remove
obstruction from hose.
2. Empty and clean dust cup
filter.
6
Warning: Always unplug from electrical outlet before opening the dust cup (container) (10).
Note: Dust cup filter (8) must be used when operating the hand vacuum.
1. To open the dust cup (container) (10), push button (1) and pull out the dust cup (10).
Verify that the dust cup filter (8) is inside, then attach the dust cup (container) (10)
to the hand vacuum.
2. To use the Hand Vacuum with the shoulder strap (5), attach it to the unit as shown below.
3. To attach the cleaning brush (6) or crevice brush (7) to the Hand Vacuum, push brush
into the suction hole (3), as shown below.
4. To use the flexible hose (11), push the end of the hose into the suction hole (3), then
attach the desired brush (6 or 7) to the other end of the flexible hose (11), as shown
below.
ASSEMBLY
3