Frigidaire CGES3045KB2 Use & Care Manual page 14

Built-in
Table of Contents

Advertisement

Bridge
surface
radiant
element
(Model¢ only)
The cooktopofyour appliance i sequippedwitha "BRIDGE"
surface element located at the left f rontand middle(Fig.
i) positions. The Bridgecan be used when cookingwith
rectangular (like a griddle) o r ovalshaped cookware.The
element will maintain an even temperaturesetting a cross
bothportions o ftheBridge. I fneeded fornormalcookware,
theBridge element canwork like a single elementwithout the
Bridge(Fig. 4).The ® symbol indicates thatonlythefront
potion will heat(Fig. 2).The _ symbol indicates thatboth
front and middleportions w ill h eat(Fig. 3 ).You may switch
from either coil setting a t any time duringcooking.
To Operate the Bridge Surface Element
1.
Place correctly sized cookware on the Bridge surface
element.
2.
Push in and turn the control knob as shown in Figure
2 to heat the front portion of the Bridge element for
normal shaped cookware or in Figure 3 for larger
or rectangular shaped cookware. Turn the knob to
adjust the setting if needed. Start most cooking
operations on a higher setting and then turn to a
lower setting to finish cooking. Each surface element
provides a constant amount of heat at each setting.
A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates
the cookware is too small.
Please note that not all
cookware will fit the Bridge element correctly.
3.
When cooking has completed, turn the surface
control knob to OFF before removing the cookware.
The BRIDGE element may also be used in combination
with the left rear single element (Fig. 6). Because these
elements have 2 different controls, one element can be
used to cook while the other element may be used to
keep food warm.
OFF
Figure 2
hi
0
Figure 1
OFF
o
hi
Do not place plastic items such as salt and pepper
shakers,
spoon
holders
or plastic wrappings
on
cooktop when it is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.
Do not allow
aluminum
foil, or ANY material
that
can melt to make contact with the ceramic glass
cooktop,
If these items melt on the cooktop they will
damage the ceramic cooktop.
The surface"Element
On" indicator lights will glow when
one or more elements are turned on. A quick glance at
these indicator lights when cooking is finished is an easy
check to be sure all surface elements are turned off.
Figure 4
Front portion
only
Figure 5
Front & Middle
portions
Figure 3
Figure 6
Front & Middle
plus Left Rear
Radiant surface elements may appear to have cooled
after they have been turned
OFF. lie
(Hot Element)
message will turn ON and will continue to glow until the
glass cooktop has cooled down to a moderate level. The
glass surface may still be hot and burns may occur if
the glass surface is touched before the indicator light has
turned OFF. The message may remain on even though
the controls are turned OFF.

Advertisement

Table of Contents
loading

Table of Contents