Advertisement
STEP 2: (SEE FIGURE 2)
,
Assemble the latch lock subassembly to the rear
tongue using two 1/4" x 1" hex bolts (E) and 1/4"
nylock nuts (J). Tighten.
Assemble the plastic cap (O) to the front end of the
rear tongue.
LATCH LOCK
(E) 1/4" x 1"
SUBoASSEMBLY
HEX BOLT _
_/
/
REAR
TONGUE
i
i
/
(O) PLASTIC CAP
(J) 1/4" NYLOCK NUT
FIGURE 2
STEP
4: (SEE
FIGURE
4)
Assemble the hitch bracket to the front tongue using
two 3/8" x 1" hex bolts (B) and 3/8" hex nylock nuts
(L). Tighten.
Assemble the teg stand bracket to the front tongue
using two 5/16" x 1" hex bolts (C) and 5/16" nylock
nuts (K). Tighten.
LEG STAND
BRACKET
(B) 3/8" x 1"
HEX BOLT
\
(K) 5116" NYLOCK NUT
(L) 3/8" NYLOCK NUT
FIGURE 4
STEP
3: (SEE
FIGURE
3)
,
Lay the rear tongue (open side facing up) onto the
Wheel Support. Assemble the axle through the wheel
support and the tongue.
AXLE
/
REAR
TONGUE
\
WHEEL
SUPPORT
FIGURE 3
STEP
5:
(SEE FIGURE 5)
,
Place the front tongue inside the rear tongue as
shown in figure 5, Fasten the tongues together using
a 3/8" x 4" hex bolt (A) and a 3/8" nylock nut (L),
Tighten,
leaving the nut just loose enough that the
tongues can pivot freely,
,
insert the 3/8" x 4" clevis pin (G) through the tongues
and secure with a 1/8" hairpin cotter (M).
FRONT
(M) 1/8" HAIRPIN
TONGUE
COTTER
318"
NYLOCK NUT
©
(G) 3/8" x 4"
CLEVIS PIN
(A) 3/8" x 4"
HEX BOLT
FIGURE
5
5
Advertisement
