Advertisement
STAND-N-STOW
TM
CABINET
LOCKING
KNOBS
SLOTS
HEXBOLT
MOUNTING
HOLES
LOCK
WASHER
WASHER
Fig. 3
LEGSTAND
STORAGEAREA
Fig. 4
TO MOUNT
MITER
SAW
See Figure 5.
•
Insert the supplied 3/8 in. machine bolts through the
holes in the miter saw base. Each of the four mounting
holes should be bolted through the miter saw base
securely using supplied 3/8 in. machine bolts, lock
washers, and hex nuts as shown in figure 5.
•
Tighten all four bolts securely.
MITER
WASHER
HEXNUT
SAW BASE
Fig. 5
MAKING
A MOUNTING
BOARD
When mounting a saw other than the 212340, 212380, or
the 212010, create a mounting board (at least 3/4 in. thick
plywood) to secure the miter saw to the leg stand.
To pre drill holes:
• With a pencil, mark holes on the mounting board where
it will bolt to the Stand-n-Stow
TM
cabinet.
•
Drill holes large enough to fit 3/8 in. machine bolts
through both the mounting board and Stand-n-Stow
TM
cabinet.
To mount miter saw to mounting
board:
•
Insert the 3/8 in. machine bolts through the holes in
the miter saw base. Each of the four mounting holes
should be bolted through the mounting board and
through the miter saw base securely using 3/8 in. ma-
chine bolts, lock washers, and hex nuts (not included).
Bolts should be of sufficient length to accommodate
the miter saw base, lock washers, and the hex nuts.
• Tighten all four bolts securely.
Once the miter saw has been bolted to the mounting
board, attach the mounting board and miter saw assem-
bly to the Stand-n-Stow
TM
cabinet according to the steps
as noted in the previous section, Mounting the Stand=n-
Stow
TM
Cabinet Base to the Leg Stand.
Advertisement
