Download Print this page

Frigidaire CFEF357GS3 Use & Care Manual page 17

Hide thumbs Also See for CFEF357GS3:

Advertisement

Cleaning Various
Parts of Your Range
Beforecleaning any part of the range,be sure all controls are turned OFF and the range is COOL. REMOVE SPILLOVERS AND HEAVY
SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF MAJOR CLEANING LATER.
Surfaces
How to Clean
Aluminum
& Vinyl
Use hot, soapy water and a cloth. Dry with a clean cloth.
Painted and Plastic Control
Knobs, Body Parts, and
DecorativeTrim
Using a soft cloth, clean with mild dish detergent and waterora 50/50 solution of vinegarand water.
Follow by rinsing the area with clean water; dry and polish with a soft cloth. Glass cleaners may
be used if sprayed on a soft cloth first. DO NOT spray liquids directly on the control pad and display
area. Do not use large amounts of water on the control panel - excess water on the control area
maycause damage to the appliance. Do not use other liquid cleaners, abrasive cleaners, scouring
pads, or paper towels - they will damage the finish. To remove control knobs, turn to the OFF
position; grasp firmly and pull straight off the shaft. To replace knobs after cleaning, line up the
flat sides of both the knob and the shaft; then push the knob into place.
Stainless
Steel (some mod-
els) Oven Door & Drawer
Front Panel and Decorative
Trim
Surface Elements and Drip
Bowls (some models)
Clean stainless
steel with hot, soapy water and a dishcloth. Rinse with clean water and a
cloth. Do not use cleaners with high concentrations
of chlorides
or chlorines. Do not
use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for
cleaning stainless steel. Always be sure to rinse the cleaners from the surface as bluish
stains may occur during heating that cannot be removed.
Surface elements can be unplugged and removed to make cleaning the drip bowls easier.
The surface elements clean themselves when they are turned on. Food spilled on a hot
element will burn off. Food spilled on a cold element can be cleaned with a damp cloth any
remaining soil will burn off the next time element is used. NEVER IMMERSE A SURFACE
ELEMENT IN WATER. To remove surface element and drip bowls, follow the instructions
under General Cleaning.
To clean drip bowls, wash in hot, soapy water or in the dishwasher. Rinse and dry while still
warm. Hard-to-remove, burned-on soils can be removed by soaking the drip bowls for about
20 minute in a slightly diluted liquid cleanser or solution made of equal parts ammonia and
water. A nylon scrubber may be used after soaking. DO NOT use abrasive cleanser or steel
wool, as they will scratch the surface. Always rinse with clean water and polish, and dry with
a soft cloth. To replace drip bowls and surface elements, follow the instructions
under
General Cleaning.
Porcelain Enamel
Broiler Pan and Insert,
Cooktop, Surface under
Cooktop, Door Liner, Body
Parts and Warmer Drawer
and Drawer Cavity
Oven
Racks
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution
of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub
with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or
the porcelain may become damaged during future heating. DO NOT use spray oven cleaners
on the cooktop.
Oven racks should be removed, or else their finish will dull and their color turn slightly
blue. If they do go through the self-clean cycle, wait until the oven has cooled, then remove
the oven racks and rub their sides with wax paper or a cloth containing a small amount of baby
or salad oil; this will make the oven racks glide easier back in and out of their positions.
Oven door
To clean oven door, wash with hot, soapy water and a clean cloth. DO NOT immerse the door
in water.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven material, on
self cleaning models, which is essential for a good seal. Care should be taken not to rub,
damage or remove the gasket.
17

Advertisement

loading