Advertisement
Operating Instructions
(continued)
Status Indicator Lights
The SENSING
light (some models) comes
on at
the beginning
of the selected
cycle and will remain
on until the end of the sensing sequence.
The WASHING
light (some models)
comes
on at
the beginning
of cycle and remains
on until the end
of the main wash.
The DRYING
light (some
models)
indicates
the
drying portion of the cycle. The light will come on
when either drying option is selected.
When the SANITIZE
option is selected,
the
SANITIZED
light will glow when the SANITIZE
cycle is finished.
If the dishwasher
did not properly
sanitize
the dishes,
the light will not come on. This
can happen if the cycle is interrupted.
The light will
remain on until the door is opened.
The RINSING
AGENT
LOW light (some models)
comes
on at the end of a cleaning
cycle when the
rinse agent reservoir
is low. The light will remain on
through
5 successive
cycles or until the reservoir
is filled.
The CLEAN
light (some models)
will come on at
end of cycle and remain
on until door is opened.
Child Lock Controls
To prevent
children
from accidently
changing
the
dishwasher
cycle or starting
the dishwasher,
lock
the dishwasher
controls
by pressing
and releasing
the RINSE
ONLY pad (some models)
or the NO
HEAT DRY pad (some models)
for 3 seconds
while the door is latched.
An indicator
light on the
lock graphic
pad will illuminate
when the controls
are locked and no new selections
can be made
until the lock is released.
To unlock the controls,
press the RINSE
ONLY pad or NO HEAT DRY
pad until the indicator
light goes out.
Status Window
The STATUS
window,
available
on some models,
indicates
the following
activity:
Note:
The time remaining
could suddenly
increase
or drop several
minutes. This means the Smart
Sensor
has checked
the soil level and determined
if additional
water fills are needed or if water fills
can be deleted.
1H-24H
...........
Number of delay start hours.
The last hour will count down in
minutes.
CL ..................
Close dishwasher
door. The
status indicator
lights will also
flash to indicate
current cycle
status.
HO .................
Flashes to indicate a water heat
delay.
MINUTES
.........
Number of minutes
left in cycle
(1-99). If cycle is longer than 99
minutes, a small light will appear
in the lower right corner and
remain on until time counts
below 99.
PF ..................
Appears
in window
when
dishwasher
is first installed,
or
when power has been
interrupted.
HI-TEMP
WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL
pad.
LO .........................
Appears
in window when the
rinse aid dispenser
is low and
needs to be refilled.
Advertisement
