Advertisement
Care and Cleaning
of Stainless
Steel (Stainless
Steel models
only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required
for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the GeneraJ Care & Cleaning section in
this Use & Care Guide.
Hinge
support
_geleverhook
Lock engaged for door removaJ
Figure 1
NGE SLOT - Door re-
moved from the oven
Figure 2
Hinge lever
Lock in normaJ position
Figure 3
Removing
and Replacing
the Oven
Door
_The
door is heavy. For safe, temporary storage, lay the door fiat with
the inside of the door facing down.
To Remove Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge
lever hooks (Figure 1). You may have to apply a little downward pressure on
the door to pull the locks fully over the hinge lever hooks.
3. Grab the door by the sides and pull the bottom of the door up and toward you
to disengage the hinge supports. Keep pulling the bottom of the door toward
you while rotating the top of the door toward the range to completely disen-
gage the hinge levers (Figure 2).
4. To clean oven door, follow the instructions provided in the GeneraJ Care &
Cleaning table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the
door to the fully opened position.
2. Disengage the lock from the hinge lever hooks on both sides (Figure 3).
Note: Make sure the hinge supports are fully engaged before unlocking the hinge
levers.
3. Close the oven door.
Speciam Door
Care instructions
- Most oven doors contain
glass
that can break.
Read the following recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching,
hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time.
17
Advertisement
