Frigidaire FAH08ET1T10 Use & Care Manual page 7

Operating Instructions
(continued)
TO OPERATE ON FAN ONLY:
LIGHT ON
YOU WILL SEE:
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air on some models.
(Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can
choose any fan speed you prefer. (Except "Auto Fan").
During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. Fan Only
cannot be selected when the unit is in the "Remote Sensing" mode. (on those units with that feature).
TO USE THE ENERGY SAVER
FEATURE;
YOU WILL SEE:
.................. _ LIGHT ON ........................ :............................. :.......... :.................
\
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds
at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on.
TIMER: DELAY STOP / START
FEATURE
FIRST
DO THIS:
PRESS
TIMER BUTTON
YOU WILL SEE HOW MUCH TIME
IS CHOSEN:
THEN
DO THIS:
PRESS
TEMP/TIMER
SET BUTTON
Note: For Delay Stop, the unit must be in the On position. LIGHT ON
Note: For Delay Start, the unit must be in the Off position.
First, press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( v- ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected) or heating with maximum Fan speed (if Heat was the last mode selected.
Note: On 115V models only low speed can be selected.) The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
02009 Electrolux Home Products, Inc. All rights reserved. .=.7
/