Download Print this page

Care And Cleaning - Frigidaire FDB2410HIB0 Use & Care Manual

Precision direct wash system
Hide thumbs Also See for FDB2410HIB0:

Advertisement

Care and Cleaning
Burn Hazard
Allow heating element to cool
_,_
before cleaning
the interior.
Failure to do so can result in
burns.
Outside--Occasionally
wipe with a mild
nonabrasive
detergent
and water.
Rinse and dry.
Models with
Stainless
Steel Door--
Clean outer door with warm soapy water and a
dishcloth
or sponge.
Rinse with clean water and a
dry cloth. Do not use harsh cleaners.
Inside--The
inside of the dishwasher
is self-
cleaning
with normal use. If needed,
clean around
the tub gasket area with a damp cloth.
The filter is self-
cleaning.
A glass
trap located
in the
center of the filter
is designed
to
collect
pieces
of
broken
glass,
straws,
bones and
pits. To remove
items in glass trap,
grasp handle,
lift
out, empty and
replace.
Note:
Hard water may cause lime deposit
buildup
on the interior of the dishwasher.
For cleaning
instructions
see "Removing
Spots and Film"
section.
Overfill
Protector--keeps
dishwasher
from
overfilling
and is located in the left front corner
of
the tub.
° Clean occasionally
with
household
cleaner
containing
vinegar
or
bleach to dissolve
any
buildup.
° Overfill
Protector
should move up and
down freely about one
inch. If it does not
move, lift and clean underneath.
14
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly.
A drain air gap is
usually mounted
on countertop
and can be
inspected
by removing
the cover. This is not part
of your dishwasher
and is not covered
by
warranty.
Property Damage Hazard
Freezing temperatures
may cause water lines
to rupture.
Be sure all supply lines to and
circulating lines within dishwasher
are
)rotected.
Failure to do so could result in property
damage.
Winterizing
A dishwasher
left in an unheated
place should
be
protected
from freezing.
Have a qualified
person
do the following:
To Disconnect
Service:
1. Turn off electrical
power to the dishwasher
at
the supply
source by removing
fuses or
tripping
circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve.
Disconnect
water line from inlet valve and drain into pan.
4. Disconnect
drain line from pump and drain
water into pan.
Note: See Installation
Instructions
for more
details.
To Restore
Service:
1. Reconnect
the water,
drain, and electrical
power
supply.
2. Turn on water and electrical
power supply.
3. Fill both detergent
cups and run dishwasher
through
a POTS
& PANS cycle.
4. Check connections
to make sure they do not
leak.
Note:
See Installation
Instructions
for more
details.

Hide quick links:

Advertisement

loading