Single Oven Models; Before Setting Oven Controls; Setting Ovencontrols; Adjusting Oventemperature - Frigidaire FGB24L2ABB Use & Care Manual

Single Oven Models Only
Before Setting Oven Controls
Oven Vent Location
The oven is vented through the upper control panel trim and grille or through the
bottom grille of the upper control panel. When the oven is on, warm air isreleased
through the vents. Thisventing isnecessaryfor proper burner operation in the oven and
good baking results. DO NOT block the vents. Doing so may cause baking failures, fire
or damage to the wall oven.
Arranging Oven Racks
AL WA YSARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIORTO OPERATING
THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and
slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front
of the rack upward and slide the rack back into place.
Single Oven Models
Some models have 2 flat racks. Other models have one flat rack and one offset rack. The rungs on the offset rack are slightly
raised from the edges of the rack. This raised part of the rack isdesigned to allow easy and safe removal of foods from the lower
racks of the oven and prevent hands from contacting the hot oven door. Always use the offset rack in the lower position.
Setting Oven Controls
For setting the oven controls, refer to the section on the timer or Electronic Oven Control Guide.
Adjusting Oven Temperature
For instructions on how to adjust the oven temperature refer to Timer Section or Electronic Oven Control Guide.
General Cleaning
To Remove and Replace Oven Door
(single Oven
Models)
1. Open the door to the fully opened position.
2. Pull up the lock located on each hinge support and engage it in the hook of the hinge lever. You may have to apply a little
downward pressure on the door to pull the locks fully over the hooks.
3. Grasp the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.
4. Keep pulling the bottom of the door toward you while rotating the top of the door toward the appliance to completely
disengage the hinge levers.
5. To reinstall the oven door, reverse steps 1 through 4. Make sure the hinge supports are fully engaged before unlocking the
hinge levers.
The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.
LOCK IN NORMAL LOCK ENGAGED HINGE SLOT
DOOR REMOVED FROM
POSITION FOR DOOR REMOVAL
THE RANGE
Door Removal
10