Craftsman 320.2966 Operator's Manual page 15

NOTICE: The charger may become warm with several continuous charge
cycles. This is part of the normal operation of the charge. Charge in a well
ventilated area.
TO ATTACH BATTERY PACK (sold separately) (Fig. 3)
1. Make sure that the Worklight is turned OFF.
2. Align the raised rib on the battery pack with the grooves of the Worklight,
then attach the battery pack to the Worklight.
NOTICE: Make sure that the latch on the battery pack snaps into place and the
battery pack is secured to the tool before beginning /
operation. Fig. 3
/
TO DETACH BATTERY PACK (sold
separately) (Fig. 3)
1. Depress the battery release button J
located on the both sides of the battery _-
pack to release battery pack.
/
2. Pull the battery pack out and remove it
from the tool.
_lk CAUTION: When placing the battery
pack in the tool, be sure that the raised rib
on the battery pack aligns with the groove inside the worklight and the latches
snap into place properly. Improper assembly of the battery pack can cause
damage to internal components.
TURN ON/OFF THE MULTI-PURPOSE WORKLIGHT (Fig. 4)
Depress the switch to turn the worklight on. Depress it again to turn the
worklight off (Fig.4).
FuelGauge (Fig. 4)
This tool is equipped with a FuelGauge that
indicates the battery pack charge level.
The green LED on the FuelGauge indicates that
the battery is fully charged.
The yellow LED on the FuelGauge indicates
that the battery has used approximately one
half of its charge.
The red LED on the FuelGauge indicates the
battery pack is depleted and needs to be
charged.
Fig. 4
FuelGauge
ON/OFF
switch
2966 Manual_Revised_li 0413 Page 15