cont. (See Fig. 3)
4, Place levers back in locked position (see Steps 6 and 8 on Installing
NOTE: ALWAYS be sure that both levers are in the locked position before
peel adhesive backing from the new 1/3-sheet sandpaper,
6. Place sandpaper
in position. ALWAYS make sure that the front edge of
the sandpaper is carefully aligned with the front edge of the cushion.
Then carefully press the sticky side of the sandpaper onto the cushion.
NOTE: The sandpaper
MUST be aligned with the front edge of the cushion
in order for the sander to properly function when flush sanding.
NOTE: We recommend
that you clean the cushion occasionally
it gently with a small brush. Dust build-up on the cushion will cause the
to not stick properly,
ATTACHING DUST BAG ASSEMBLY (See Fig. 4)
To prevent the possibility of sanding dust or other
foreign objects being thrown into your face or eyes NEVER try to
operate your sander without the dust bag assembly properly installed.
Sanding dust or foreign objects thrown into your face or eyes could result
in serious personal injury.
1. Unplug the sander.
I Z_ WARNING:
Failure to unplug the sander could result in accidental
starting causing possible serious personal injury.