Advertisement
3. Toremove the tube, turn the knob
toloosen clamp; remove tube.
VACUUM A SSEMBLY
VACUUM
BAG ASSEMBLY
1. Open t he zipper onthe vacuum
bag and insert the elbow t ube.
2. Push t he small end ofthe elbow
tube through the small opening in
thebag.
Elbow
Tube
Small
/
Opening
Zipper
Opening
Rib
NOTE: Make sure edge of the small
opening
is flush against the flared area
of the elbow tube, and the rib on the
elbow tube is on the bottom.
3.
Close the zipper on the bag. Make
sure the zipper is closed completely.
4.
Remove blower tube from engine.
_ Gro ve
5.
Insert the elbow tube into the blower
outlet. Make sure elbow tube is
aligned with the blower outlet
groove.
6. Turn clamp knob clockwise to tight-
en.
VACUUM
TUBE ASSEMBLY
1. Align the lower vacuum
tube as
shown. Push lower vacuum tube
into upper vacuum tube.
Upper
Vacuum Tube
Lower
Vacuum Tube
2. Insert a screwdriver
into the latch
area on the vacuum
inlet cover.
Latch
_
_
_!_ .....
Blower
A_
]
_,
Outlet
_"
Latch Area
Vacuum
_._-_J7 - Inlet Cover
3. Gently tilt the handle of the screw-
driver toward the back of the unit
while pulling up on the vacuum
in-
let cover with your other hand.
4. Hold the vacuum inlet cover open
until upper vacuum tube is installed.
Vacuum Inlet
Retaining
Pest
Vln°, tm
Cover
5. Place the hooks on the vacuum tube
on the retaining posts; pivot tube into
position. Secure vacuum tube by
turning the knob clockwise until tight.
--
_-- _oks
6,
When converting
back to the blow-
er feature, make sure latch on the
vacuum
inlet cover is securely fas-
tened.
Advertisement
