Unpacking - Craftsman 320.2768 Operator's Manual

• Only use router tables with on=board switch=controlled receptacles.
Failure to use router tables with all the appropriate safety features could
result in serious personal injury.
• Disconnect the tool from the power source before making any
adjustments or changing cutter bits.
• if you are changing a bit immediately after use, be careful not to touch
the collet/nut or cutter bit with your hands or fingers. The heat buildup
from cutting could cause severe burns. Always use the wrench provided.
• Avoid "climb cutting;" see "Direction of Feed in" section in this manual.
"Climb cutting" increases the chance for loss of control resulting in possible
serious injury.
_, WARNING: Bits, sockets, and tools get hot during operation. Wear gloves
when touching them.
_, WARNING: Wear ear protection. Exposure to noise can cause hearing loss.
WARNING: To avoid injury, hold the tool by the insulated gripping surfaces
only. if the tool contacts hidden wiring or its own cord, exposed metal parts
of the tool could shock the operator and cause serious injury. Make sure that
hidden electrical wiring, water pipes, or other hazards are not in the cutting path.
_1, WARNING: Your router should never be connected to the power source
when you are assembling parts, making adjustments, installing or removing bits,
cleaning, or when it is not in use. Disconnecting the router will prevent accidental
starting, which could cause serious personal injury.
When unpacking the box, do not discard any packing materials until all of the
contents are accounted for:
1. Carefully lift the router out of the carton and place on a stable, flat surface.
2. Open the carton to locate the following:
• Vacuum port
• Chip shield (already installed on router)
• 1/4 inch collet/nut
• 1/2 inch collet/Nut (already installed on router)
• Collet/nut wrench
• Depth-Adjustment Wrench
• Edge Guide
• Manual
2768 Manuai_Revised_11@307 Page 10