Table of Contents
Advertisement
• Pull rope with a rapid,
continuous,
1oil arm stroke
Keep
a firm grip on start
handle
Let rope rewind
slowly
Do not tet starter
handie
snap back against
starter
e Repeat preceding two instructions until engine fires
When engine starts, move choke lever on engine
halfway between CHOKE and RUN
NOTE:
If engine
does
not tire after three
attempts,
move choke
lever halfway
between
CHOKE
and RUN
position
and try again
See figure
9
Chok?
jLZ "_
oFF
Throttle
Control
FIGURE
9..
e Move throttle contro! to IDLE position for a few
minutes warm-up
Move choke lever 1o RUN posi-
tion as engine warms up
NOTE: In order to idle smoothly, a new engine may re-
quire 3 to 5 minutes running above stow idle speed
idle speed has been adjusted to be correct after this
break-in period
TO STOP ENGINE
o Move throttle control lever to STOP position
See
figure 9.
o Disconnect
spark plug wire and move away from
spark plug to prevent accidental starting while equip-
ment is unattended.
HOW TO USE YOUR CHIPPER-SHREDDER
Do not attempt to shred or chip any material other than
vegetation
found in a normal yard (leo, branches,
leaves, twigs, etc.)
&
WARNING:
THE
CHIPPER-SHREDDER
DISCHARGES
MATERIALS
WITH
CON*
SIDERABLE
VELOCITY,
KEEP
AWAY
FROM
THE AREA
AROUND
THE CHUTE
DEFLECTOR,,
ALWAYS
STOP
THE
ENGINE
AND DISCONNECT
THE SPARK
PLUG
WIRE
WHEN
REMOVING
OR AT-
TACHING
THE
BAG
WHEN
CHANGING
CONTAINERS
OR WHEN
REMOVING
THE
SHREDDED
MATERIAL,
WEAR
SAFETY
GLASSES
AND
GLOVES
WHENEVER
USING
YOUR
CHIPPER-SHREDDER.
The chipper-shredder
is designed lot three different
methods o1 operation
@ Leaves and small branches up to 1/2" diameter can
be fed into the hopper assembly when it is in the
raised
position
See
figure
!0
If it becomes
necessary
to
push
material
into
the
chipper-
shredder, use a small diameter stick--NOT
YOUR
HANDS
The stick should be small enough that it
will be ground up if gets into the impeller assembly
WARNING:
DO
NOT
PUT
MATERIAL
LARGER THAN 1/2" IN DIAMETER INTO
THE HOPPER ASSEMBLY, MATERIAL UP
TO A MAXZIMUM OF 3" IN DIAMETER
MATERIAL
MAY
BE FED
INTO
THE
CHIPPER CHUTE. DO NOT ATTEMPT TO
SHRED
OR
CHIP
ANY
MATERIAL
LARGER
THAN
3"
IN
DIAMETER.
PERSONAL
INJURY
OR DAMAGE
TO
THE MACHINE
COULD RESULT°
opper
Assembly
FIGURE 18.
Leaves and small twigs can be raked into the hop-
per assembly when the hopper assembly is lowered
to the ground
See figure 11 Small branches up to
tt2"
diameter
can also be fed into the hopper
assembly in this position
See figure 12
Hide quick links:
Advertisement
Table of Contents
