Advertisement
Rotatethe Buffer-Polisher a s shown in Fig. 4. Then
cover the same area again moving the Buffer-
Polisheras shown in Fig. 5. Repeatthis until you
havecompletedapplyingwax to the entire surface.
Whenapplyingwaxto areaswhereonly partialuseof
the polishing bonnet is possible,someexcesswax
will be thrown from the bonnet.SeeFig. 6. NEVER
APPLY DOWNWARD PRESSURE ON YOUR
BUFFER-POLISHER. LET THE WEIGHTOF THE
TOOL DO THE WORK. APPLYINGDOWNWARD
PRESSURE O N YOURBUFFER-POLISHER COULD
RESULT IN MOTOR OVERHEATINGCAUSING
SERIOUSDAMAGE.NOTE:YOU ARE APPLYING
DOWNWARD PRESSURE WHENTHE POLISHING
HEADDOESNOTROTATE.
Whileyouarewaitingforthe waxto dryto a haze, a p-
ply waxto a clean cloth andapply by handto those
areasnot reachedby the Buffer-Polisher, s uch as
arounddoor handles,headlights,andantenna.
WARNING:
A LWAYS WEAR SAFETY
GLASSES OR
EYE SHIELDS
WHEN
OPERATING
YOUR BUFFER-
POLISHER.
IF THE OPERATING
IS DUSTY, ALSO
WEAR A FACE OR DUST MASK. FAILURE TO DO SO
COULD
RESULT
IN DUST OR LOOSE PARTICLES
BEING THROWN
INTO YOUR EYES, RESULTING
IN
POSSIBLE
SERIOUS
INJURY.
REMOVING
WAX
Remove the first
polishing
bonnet and place the se-
cond
polishing
bonnet
on your Buffer-Polisher
with
the black
side
of the bonnet
facing
outward.
See
Figure 7. To remove the wax move the slide switch to
the position
marked
"Hi"
and follow
the same pat-
tern you used to apply the wax. As you remove the
wax a fine dust will develop
on the surface.
After you
have completed
removing
all the wax use a clean dry
cloth to remove the dust. Use another clean dry cloth
to remvoe the wax from the areas where you applied
the wax by hand. NOTE: If you don't produce
an im-
mediate shine, or if the wax doesn't
come off easily,
either
the wax hasn't dried completely,
or you have
applied
too much wax. If the wax hasn't dried com-
pletely,
wait a few minutes
before removing
it. If you
have
applied
too
much
wax,
work
your
Buffer-
Polisher
back and forth as shown
in Fig. 7.
BUFFING
Fig. 4
Fig. 5
Fig. 6
The buffing
bonnet
packed with your Buffer=Polisher
can be used to produce a brighter
finish.
After you
have removed the wax and the fine dust from the surface, place the buffing
bonnet on your Buffer-Polisher
with the lamb's wool facing outward.
Place the Buffer.Polisher
flat on the polished
surface and move the
slide switch to the position marked "Hi".
Rotate the Buffer-Polisher
in the same manner as when applying
wax. Note: Do not apply downward
pressure since applying downward
pressure reduces
the amount of
rotation of the polishing head.
Page 5
Fig. 7
Advertisement
