Advertisement
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
CENTERPOSITION
(LOCK)
SELECTOR
REVERSE
BATTERY PACK
LMCHES
SWITCH
TRIGGER
FORWARD
Fig. 3
,_i
CAUTION:
To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
TO INSTALL
BATTERY
PACK
See Figure 4.
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
•
Place battery pack in your drill. Align raised rib inside
drill with groove on battery pack. See Figure 4.
DEPRESSLATCHES TO
RELEASE BATTERY PACK
Fig. 4
•
Make sure the latches on each side of your battery
pack snap into place and battery pack is secured in
drill before beginning operation.
,_
CAUTION:
When placing battery pack in your drill,
be sure raised rib inside drill aligns with groove on
battery pack and latches snap in place properly.
Improper assembly of battery pack can cause
damage to internal components.
TO
REMOVE
BATTERY
PACK
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
Locate latches en end of battery pack and depress to
release battery pack from your drill. See Figure 4.
Remove battery pack from your drill.
8
Advertisement
