Table of Contents
Advertisement
1. Placethe unitizedfence upsidedown on a flat surface as shown
in Fig. #5a & #Sb.
2. Orient the retractableguard as shown in Fig, #5a & #5b.
Positionand hold the spring over its hub such that formed end of
spring wraps over the guard as shown in Fig. #So & #5b.
3. While holding the spring overthe hub, and formed end over the
guard, position and press the straight leg of spring against surface
'X' to align hole in hub over boss on unitizedfence (see Fig. #5a &
#5b). Slip the guard over the boss, Spring wil! now be trapped
betweenthe guard and the fence.(Spring diameter is bigger than
the hub diameter.You will need to use both handsto hold spring
in proper position,).
4, Tightly secure retractableguard in placeusing set! threading #8-
10 x _" long pan head ptasformscrew and a flat washer as shown
in Fig. #5a & #5b,
5, Swing guard a few times in the direction of arrow to see that it
retractsout freely by itself and returns to its normal position over
the routertable hole. See Fig.#5a & #5b.
NOTE:If the guard does not retractout freely, loosenscrew just
enough until it does retract out freely and snaps back to normal
forward position by itself,
6. Turn the unitizedfence right side up.
f.'K._URE 5 a
FIGURE5b
ATTACHMENT OFUNITIZED FENCE ASSEMBLY
TOTABLE
FROMTABLE.
ALWAYS UNPLUGROUTER BEFORE
ATTACHING FENCE TOAND REMOVING
1. Assembleunitized fenceassemblyto table as shown in Fig. #6.
2. Insert one of the _-20 x 1_" long hex head bolts through the
hole in the tabletop (from the underside)and the slot in the fence.
3. While holding the head of the bolt in the hex recesson the
undersideof the tabletop,placea flat washer over the bolt and
install a large '_-20 knob onto the bolt to loosely secure the fen_:e.
4, Repeatfor tile other slot,
NOTE:The unitized fenceassemblycan be attachedto bible with
either sidefacing the front, Touse other side, just remove the
knobs and turn the fencearound.
RGURE6
7
Hide quick links:
Advertisement
Table of Contents
