Assembly Of Miter Gauge; Alignment Of Unitized Fence To Miter Bar Slot; Operation - Routing Using Frontside Of Unitized Fence; Adjusting Depth And Height Of Cut - Craftsman 25481 Instructions For Assembly And Operation Manual

Assembleprotractor headtOmiter bar as shown in Fig. #13.
1. Measuredistancefrom each end of unitized fence to edge 'E' of
miter bar slot on thetable as shown in Fig. #t4. If both distances
are the same,the fence is parallelto miter bar sfot. !t not, loosen
largeknobs and adjust fenceaccordingly,Tighten both knobs.
2. Position miter gaugeon tableas shown in Fig #14.
.. _4-417 X 3/4 LG
,_" PANHEAD
MACHINE SCREW
__"t¢"*......._ -_-- POtNTER
HEX
/
3,'t6'f'ALNUT ............... \,
PALNU_ TOBE PU,S'HEO O NTO STUD UNTIL #t0-32 x 3,;4" LG.
tT BOTTOMSOUT AGAINSTMtTER BAR CARRtAGE BOLT
FIGURE13
ALWAYSUNPLUGTHE ROUTER BEFORE MAKINGANY SETTING,
ADJUSTMENTS ORCHANGING BITS,
WHENROUTING, A LWAYSFEED AGAINSTTHE ROTATION OF
THE CUFrER FEED WORKPIECE IN THE DIRECTION OFARROW
AS SHOWNONTHE LABELONTHESIDE OFTHE FENCE BEING
USED(when facing the table front).
Theunitized fenceon your table is providedas a guide, against
which the workpieceshould be heldfor accuracy in routing. Free
hand routing (not holding work against the fence) is hazardous
and should be strictly avoided.
Wet/dry vac with eitller 2S" diameteror 1/" diameter hose nozzle
should be connectedto the dust collectionattachmentwhen using
the router table,
FIGUREt4
tn order to retractthe guard and haveful! access to the router bit
for making adjustments,select a board that is smooth with edges
and endstrue to eachother and its surfaces,Keepin mind the
foi!owing as wel!:
1. Mark lines 'A and 'B' on the end of this board. Line 'A' for
desireddepth of cut (amount of material you want Io remove)and
line 'B' for desiredcutting heighL SeeFig. #I 5,
2. Position this board against theface of tile fencewith edge
resting on tabletop and end marked with lines 'A' and 'B' dose to
the bit. SeeFig, #t5. (This will retractguard inside tenceand
provideaccessto the bit for making adjustments, MAKESURE
ROUTER tS UNPLUGGED WHENMAKINGADJUSTMENTS.)
3, Loosen both large knobs that allow movement of fence and
move fence forward and backwarduntil outermost cutting edge ef
router bit is alignedwith line 'A'. Tighten both knobs.
FfGUREt5
t0