Download Print this page

Craftsman 486.245312 Owner's Manual page 6

15 gallon 35 psi sprayer

Advertisement

Assemble t helargeandsma!l s praygunclipsto the
sideofthetankusingtwo#10x 1/2"screws and#10
lockwashers, Seefigure7,
#10 x 1/2"
SCREW
SPRAY
GUN
#10 LOCK
CLmP (LARGE)
WASHER
"--.
SPRAY
GUN
....
CUP
(SMALL)
FIGURE 7
Slide a 3/8" hose clamp onto the boom connecting
hose, Place the end of the hose through the conduit
clamp (attached to the pump) and then slide a second
3/8" hose clamp onto the hose, Leave hose clamps
loose for now, See Figure 8,
Push the hose onto the hose adapter in the end of
the "On-Off" valve, Tighten the hose clamp around the
hose and adapter, See figure 8,
Position the valve and hose clamp up against the
conduit clamp, Slide the other hose clamp against the
other side of the conduit clamp, Tighten the clamp
without collapsing the hose, See figure 8,
Slide the coiled hose clamp onto the spray gun hose
and then push the hose onto the hose adapter on the
1/4" tee fitting, Tighten the hose clamp around the
hose and adapter, See figure 8,
,
Snap the spray gun into the clips on the front of the
tank, (The large clip holds the spray gun handle and
the small dip holds the wand,) Refer to figure 7,
' \\
\\\
3/8" HOSE CLAMPS
\
COmLED HOSE CLAMP
-SPR_,Y GUN
J
HOSE
CONNECTmNG
1/4" TEE
CONDUmT
HOSE
J
CLAMP
FIGURE
8
VIEWED
FROM
FRONT
To connect the wire harness to the tractor, attach the
red wire to the positive post on the battery or to the
"HOT" connection on a tractor switch or ammeter,
The brown wire may be grounded or connected to the
negative battery post, See figures 9 and 10,
IMPORTANT: This sprayer should be connected to 12
volt batteries only!
PUMP SWITCH
QUICK COUPLER
RED
RED
_©5+
iBATTERY
BROWN
BROWN
....................................
FIGURE 9
DANGER!
Never allow negative pin on
plug to come in contact with positive
"hot" post on battery, Fire or explosion
may result!
PLUG
NEGATUVE
PIN
FIGURE 10

Advertisement

loading