Advertisement
WARNING
• Study, understand,
and follow all
instructions
with and on this device
before operating
this device.
• Do not exceed rated capacity.
° Use only on hard, level surfaces capable
of sustaining
rated capacity loads.
• Lift only on areas of the vehicle as
specified
by the vehicle manufacturer.
• This is a lifting device only. Immediately
after lifting, support the vehicle with
appropriately
rated vehicle stands.
• Never work on, under, or around a load
supported
only by this device.
o Do not move or dolly the vehicle while on
the jack.
• No alterations
shall be made to this
product.
° Failure to heed product markings
or
warnings
may result in personal
injury or
property
damage.
CAUTION
BEFORE
USING
Occasionally
during shipment
and/or
handling
the hydraulic oil can become
unstable
or air can get trapped in the
system,
both of which can interfere with the
jacks lifting performance.
To stabilize the oil it is recommended
to
cycle the jack a few times prior to putting
a load on it.
To release air from the hydraulic system:
° Open the release valve by turning the
jack handle counterclockwise,
but
never by more than 1/2 full turns.
• Remove the air vent valve from the
cylinder. (see Fig. 4)
° Rapidly pump jack handle through
several full strokes.
° Replace the air vent valve into the
cylinder again and jack is now ready to
use.
BEFORE
EACH
USE
Make a visual inspection
before each use
of the floor jack by checking
for abnormal
conditions,
such as cracked welds, leaks
and damaged,
loose, or missing parts.
DAMAGE
TO JACK
If you think jack has been subjected
to an
abnormal
load or shock, have it inspected
for damage
at a Sears Service
Center
before using it again.
TO ASSEMBLE
THE TWO
PIECE
HANDLE
1. Locate the Spring Pin on
bottom end of Upper
Handle and the Fixing
Hole on the top end of
Lower Handle. (See
Fig.l)
2. Align the Spring Pin with
the Fixing Hole. Connect
the two handle pieces
together
by pressing the
Spring Pin and insert
until the Spring Pin is
locked in the Fixing
Hole.
,_p8
pnrl pper
1.
andle
2.
ng
J
3.
Fixing
Hole
FIG. 1
Lower
Handle
3
TO ASSEMBLE
THE HANDLE
INTO
THE SOCKET
Pull out and hold
the Spring Knob
(see Fig. 2)
Insert the
assembled
handle
into the Socket, until
it is firmly seated.
Release the Spring
Knob, the handle is
then fixed in
position.
/
FIG. 2 Spring Knob ._
Assembled
Handle
Handle
Socket
Advertisement
