Multi Stage Cooking - Electrolux E30MC75JPS1 Use & Care Manual

ettin
icrowave Controls 33
Mu(ti Stage
Preheat
Your oven can be programmed for up to 3 automatic
cooking sequences, switching from one power level
setting to another automatically.
Sometimes cooking directions tell you to start on one
power level and then change to a different power
level. Your oven can do this automatically.
, Suppose you want to preheat the oven at 375 °
and then continue to cook for 25 minutes at 375 °
and 20 minutes at Io mix bake.
Step
1. Press MICRO OVEN.
2. Press multi stage.
3. Press preheat.
4. Select temperature by
pressing number pad.
5. Press START.
6. Press conv bake.
7. Select temperature by
pressing number pad.
8. Press START.
9. Enter cooking time by
pressing the number pads.
Press
MICRO
OVEN
@
®
7
4>
@
7
4>
2500
Your oven can be programmed to preheat. This
feature is preset at 350°F. The temperature can be
changed to from 100°F to 450°R
- Suppose you want to preheat to 375°R
Step Press
MmRO
1. Press MICRO OVEN. OVEN
2. Press preheat. @
3. Select temperature (375°F)
'7
by pressing number pad 7 H
4. Press START _/i'N_
When the oven reaches the programmed tempera-
ture, signal will sound 1 time.
If the oven door is not opened, the oven will automati-
cally hold at the preheat temperature for 30 minutes.
After this time has elapsed, an audible signal will
sound and the oven will turn off.
Slow Cook
slow cook is preset at 300°F for 4 hours. The
temperature can be changed to below 300°F. The
cooking time cannot be changed. This feature can
be used for foods such as baked beans or marinated
chuck steak.
• Suppose you want to set oven temperature to
275°R
10. Press START.
11.Press Io mix bake.
12.Press START.
13.Enter cooking time by
pressing the number pads.
14 Press START
! NOTE
_) Step Press
(_ MIC_
1, Press MICRO OVEN. oven
2. Touch s,ow cook @
3. Select temperature (275°F) by 3
2000 pressing number pad 3.
<i:> 4:>
! NOTE
The preheat feature can only be programmed
at the first stage.
tf you do not change the temperature, omit step
3.