Table of Contents
Advertisement
ng Surface Controls
LEDMESSAGES O RLIGHT ND CATORS D SP Y
BY
MAINCONTROL
m
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
CONTROLS LOCK - This feature allows the cooktop to be locked at anytime. Touch and
hold the LOCK key pad for few seconds. If the cooktop is in use, it will be impossible to
enter in the lock mode. All elements need to be turned OFF. When entering in the lock
mode, a beep will sound and the Lock Indicator Light will glow (Fig. 2). Once locked, no
other displays will glow and no Cooking Zones will activate, but the Minute Timer Feature
will be available. To turn the Controls Lock OFF, touch and hold the LOCK key pad for few
seconds. A beep will sound, the Lock indicator light will turn OFF (Fig. 1) and the cooktop
may be used normally.
COOKTOP POWER - The Cooktop POWER key pad activates the entire Cooktop. To
power the cooktop, touch and hold the POWER key pad. A beep will sound and the Power
LED will glow (See Fig. 4). The cooktop will be in a ready mode. If no other key pads are
touched the Cooktop Main POWER will turn OFF automatically. To turn the Main Power
OFF touch and hold the Main POWER key pad. A beep will sound and the Power Indicator
Light will turn OFF (See Fig. 3).
ERRORS CODES XX- The Minute Timer display digits showing an error code. "E:' (Fig.
5) and a two digit number error code (Fig. 6) will flash in turn in the Minute Timer display.
lmW
Fig. I
Fig. 2
/!/!
Fig. 3
Fig. 4
IB/Ii
Fig. 5
Fig. 6
U
T ND CATORSD SP Y BYCOOK NGELEMENT
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
COOKING ZONE ON/OFF PAD - Each Cooking Elements have separate ON/OFF key
pads. Once the Main Power key pad has been touched to activate the cooktop, touch the
corresponding Cooking Element ON/OFF key pad once to active the Cooking Zone
needed. The indicator light located above the key pad will glow (Fig. 8). If the correspond-
ing hi + (increase), meal or - Io (decrease) key pad is not touched, the request to turn the
Cooking Element ON will cancel and the Cooktop Main Power will turn OFF. To set a
Cooking Element power level touch the corresponding Cooking Element hi + (increase),
meal or - Io (decrease) key pad once. To turn OFF a Cooking Element, touch the Cooking
Element ON/OFF key pad once. The Cooking Element Indicator Light will turn OFF (Fig. 7).
HOT SURFACE iNDiCATOR
LIGHT = After using any of the single, dual or triple radiant
element positions the cooktop will become very hot. Even after turning the control to OFF, the
cooktop will remain hot for some time. The hot surface indicator light will turn on (Fig. 9) if the
cooktop is still hot and will remain on until the heating surface area has cooled sufficiently. If
the indicator light is on, the control can still be turned ON again for use.
Fig. 9
Advertisement
Table of Contents
