Setting Oven Controls - Electrolux E30EW7CEPS3 Use & Care Manual

Figure 1
Setting Oven Controls
SE (NG THECLOCK
m [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The _;_) or (0,) pad is used to set the clock. The clock may be set for 12 or24 hour time of
v V
day operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1). Note: The clock
cannot be set when the oven is on.
When PF appears in the display, press (_)oA,o,L or @. No sound will be heard, but after 10
seconds a beep will sounds and PF will disappear.
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
To set the clock (example below for 1:30):
1. Press @ or (_. "CLO" will appear in the display (Figure 2).
2. Press Q ('_ Q pads to set the time of day to 1:30 (Figure 3). "CLO" will
appear in the display. Press _ or Q. "CLO" will disappear and the clock
will start (Figure 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold _ or _
for 8 seconds (Figure 3). While holding the pad
V V
down the current time of day will remain and "CLO" will disappear from the
display (Figure 4). CONT(NUE holding the pad until a beep is heard.
2. The display will show either "12: Hr" (Figure 5) or "24: Hr" (Fig.6).
3. Press _ or _
to switch between the 12 and 24 hour time of day display.
V V
The display will show either "12:Hr" (Figure 5) or "24:Hr" (Figure 6).
ess (_ or (_ to accept the change or press (_) or _ to reject
4. Pr the
S_RT _ C_C_
change.
5. Reset the correct time as described in To set the Clock above. Please note
that if the 24 hour time of day mode was chosen, the clock will now display
time from 0:00 through 23:59 hours.