Changing The Batteries - Craftsman 315.212010 Operator's Manual

CHANGING
THE BATTERIES
See Figure 51.
[] Unplug the saw.
[] Rotate and hold lower blade guard up.
[] Using the hex key (1/16 in.) provided, loosen and
remove the screw from the battery cover then separate
the cover from the laser guide. Lower the blade guard.
[] Remove the three button cell batteries.
NOTE: Replace the batteries with button cell batteries
that have a rating of 1.5 volt and 100 mAh (milliampere
hour) minimum (number 76 series or equivalent).
When replacing the batteries, the laser guide should be
thoroughly cleaned. Use a soft paintbrush, or similar
device, to remove all sawdust and debris.
[] After cleaning the laser guide and replacing batteries,
secure battery cover to laser guide using the screw.
Tighten screw securely.
CAUTION: Use of controls or adjustments or per-
formance of procedures other than those specified
herein may result in hazardous radiation exposure.
BATTERY
COVER
BATTERIES
NEGAT(VE (-)
SCREW
BATTERY
COVER
Fig. 51
36