Carton Contents; Vacuum Bag Assembly; Blower Tube Assembly - Craftsman 358.797290 Operator's Manual

is not factory equipped with a spark ar-
restor;, however, a spark arrestor is
available as an optional pad. If a spark
arrestor is required in your area, con-
tact Sears Service for the correct kit.
The spark arrestor, blower tubes, and
nozzles must be assembled to unit to
be in full compliance with regulations.
SPECIAL NOTICE: Exposure to w'ora-
tJons through p_longed useof gasoline
powered hand tools could cause blood
vessel or nerve damage in the fingers,
hands, and joints of people prone to cir-
culation disorders or abnormal swelling.
Prclongeduse in cold we_ has been
linkedto bloodvessel damage in other-
wise healthypeopla.If _ occur
such as n4mbnees,pa_, lossof
strength,change in skincolor or texture,
or lossof feelingin the fingers,hands, or
joints,discontinue the use of this tool
and seek medicalattention.An
antivibrstion systemdoes not 9uarantse
the avoidanceof these problems.Users
who operate powertooison a continual
and rsgular basis must monitor clssely
their ph_'w,al conditionand the condition
ofthis t ool.
CARTON CONTENTS
Check carton contents against the fol-
lowinglist.
Model 358.797290
• Blower
• Blower tube
• Vacuum bag
• Upper vacuum tube
• Lower vacuum tube
• 2-Cycle Engine Oil
NOTE: It is normal for the fuel filter to
rattle in the empty fuel tank.
ASSEMBLY
WARNING: If received assembled,
repeat all steps to ensure your unit is
properlyassembled and all fasteners
are secure.
• No tools are required for assembly,
BLOWER TUBE ASSEMBLY
If you have already assembled your
unit for use as a vacuum, remove the
vacuum tubes and collection bag.
• Align the rib on the blower tube with
the groove in the blower outlet; slide
the tube into place.
BIt_w_r: Blower
• Tighten the tube clamp by tuming the
knob clockwise.
• To remove the tube, turn the knob
counterclockwise to loosen clamp;
remove tube.
VACUUM BAG ASSEMBLY
If you have already assembled your
unit for use as a blower, remove the
blower tube.
• Place the small end of vacuum bag
overthe blower outletand clamp knob.
Blower
Velcro Strap
• "lighten the Velcrc strap securely.
• Make sure the zipper on the bag is
closed completely.
• Secure the ends of the shoulder
strap by routingthe strap through the
buckle as shown.
VACUUM TUBE ASSEMBLY
WARNING Stop engine and be sure
the impeller blades have stopped turn-
ing before opening the vacuum inlet
door or attemptingto insert or remove
the vacuum tubes. The rotatingblades
can cause serious injury.
• Remove blower tube from engine.
-4-