Table of Contents
Advertisement
2
INSTALL MOWER AND DRIVE BELT
Be sure tractoris on level surface and mower suspension
arms (3) are raised with attachment lift control Engage
parkingbrake.
Cut and removetiessecudn_anti-swaybar (1) and belts.
Swinganti-swaybar to leftside of mower deck.
•
Slidemowerundertractor.
IMPORTANT:
CHECK BELT FOR PROPER ROUTING IN ALL
MOWER PULLEY GROOVES.
Tum height adjustment knob countemlockwise until it
stops.
Lower mower suspension arms (3) with attachment lift
controL
Be sure belt tension rod {2) is in disengaged position.
Install belt into electric clutch pulley groove (8).
Place the suspension arms (3) on outward pointing deck
pins. Retain with double loop retainer springs (B).
Install front plate assembly (4) to tractor suspension
brackets (5) and retain with single loop retainer spdngs
(A) as shown.
Positionfront plate assembly between front mower brack-
ets (6). Raise deck and plate assembly to align holes
and insert flanged pins (7). Secure pins with double loop
retainer springs (B) between the plate assembly and
mower brackets.
NOTE: To assist in locating hole in flanged pin (7), the hole
in pin is inline with notch on head of pin.
•
Engage belt tension rod by pushing rod (2) into locking
bracket (9).
•
Connect anti-sway bar (12 to chassis bracket (1 O) under
left footrest and retain with double loop retainer spring
(B).
•
Tum height adjustment knob clockwise to remove slack
from mower suspension.
•
Raise deck to highest position.
•
Adjust gauge wheels (11) before operating mower.
1. Anti-sway bar
2.
Belt tension rod
3. Suspension arms
4.
Front plate assembly
5. Tractor suspension bracket
6.
Front mower bracket
7.
Ranged pin
8. Clutch pulley
9.
Locking Bracket
10. Chassis bracket
t 1. Gauge wheel
3
9
A. Single loop retainer spring
B. Double loop retainer spdng
11
2
6
8
.,p
23
Advertisement
Table of Contents
