Changing The Light Bulb; Vacation And Moving Care; Troubleshooting - KitchenAid KUWO244PBL00 Use & Care Manual

To help remove odors, you can wash interior walls with a
mixture of warm water and baking soda (2 tbs to 1 qt
[26 g to 0.95 L] of water).
4. Wash exterior with a clean sponge or soft cloth and a mild
detergent in warm water. Do not use abrasive or harsh
cleaners. Dry thoroughly with a soft cloth.
To keep your stainless steel wine cellar looking like new
and to remove minor scuffs or marks, it is suggested that
you use the manufacturer's approved Stainless Steel
Cleaner & Polish. To order the cleaner, see the
"Accessories" section.
IMPORTANT: This cleaner is for stainless steel parts only!
Do not allow the Stainless Steel Cleaner & Polish to come
into contact with any plastic parts such as the trim pieces
or door gaskets. If accidental contact does occur, clean
plastic part with a sponge and mild detergent in warm
water. Dry thoroughly with a soft cloth.
5. Replace the racks.
6. Clean the condenser coils regularly. They are located behind
the base grille. Coils may need to be cleaned as often as
every other month. This may help save energy.
Remove the base grille. See "Base Grille."
Use a vacuum cleaner with an extended attachment to
clean the condenser coils when they are dusty or dirty.
Replace the base grille.
7. Plug in wine cellar or reconnect power.

Changing the Light Bulb

NOTE: Not all appliance bulbs will fit your wine cellar. Be sure to
replace the bulb with one of the same size, shape, and wattage.
To change the light bulb:
1. Unplug wine cellar or disconnect power.
2. Slide the light shield toward the tab.
3. Press the tab down and lift the opposite end of the light
shield up.
4. Replace the bulb.
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Your wine cellar will not operate
Is the power supply cord unplugged? Plug into a grounded
3 prong outlet.
Has a household fuse blown, or has a circuit breaker
tripped? Replace the fuse or reset the circuit.
Is the Wine Cellar Control turned to the OFF position? See
"Using the Control."
The lights do not work
Is the power supply cord unplugged? Plug into a grounded
3 prong outlet.
Is a light bulb loose in the socket? Unplug wine cellar or
disconnect power. Gently remove the bulb and reinsert. Plug
in wine cellar or reconnect power.
10
5. Reinstall the light shield by inserting the tab end first. Then
6. Plug in wine cellar or reconnect power.
If you choose to turn the wine cellar off before you leave, follow
these steps.
1. Remove all wine bottles from the wine cellar.
2. Unplug the wine cellar.
3. Clean the wine cellar. See "Cleaning."
4. Tape a rubber or wood block to the top of the door to prop it
When you are moving your wine cellar to a new home, follow
these steps to prepare it for the move.
1. Remove all wine bottles from the wine cellar.
2. Unplug the wine cellar.
3. Clean, wipe, and dry it thoroughly.
4. Take out all removable parts, wrap them well, and tape them
5. Tape the doors shut and tape the power cord to the wine
When you get to your new home, put everything back and refer to
the "Installation Instructions" section for preparation instructions.

TROUBLESHOOTING

lower the light shield until it clicks into place.
A. Tab

Vacation and Moving Care

Vacations
open far enough for air to get in. This stops odor and mold
from building up.
Moving
together so they don't shift and rattle during the move.
cellar.
Has a light bulb burned out? Replace with an appliance
bulb of the same wattage, size, and shape. See "Changing
the Light Bulb."
There is water in the defrost drain pan
Is the wine cellar defrosting? The water will evaporate. It is
normal for water to drip into the defrost pan.
Is it more humid than normal? Expect that the water in the
defrost pan will take longer to evaporate. This is normal when
it is hot or humid.
The motor seems to run too much
Is the temperature outside hotter than normal? Expect the
motor to run longer under warm conditions. At normal
temperatures, expect your motor to run about 40% to 80% of
the time. Under warmer conditions, expect it to run even
more of the time.
A