Using The Edge Guide - Craftsman 320.17234 Operator's Manual

4.5 amp variable speed sabre saw
Table of Contents

Advertisement

Available languages

Available languages

TO ADJUST BASE PLATE FOR BEVEL CUTTING cent, (Fig. t5 and 15a)
6, Re4ighten the hex screws. For accurate work, it is necessary to make a trial cut,
measure the work, and reset the angle until the correct setting is achieved.
Fig. 15a
M
I Z_ WARNING:
ALWAYS clamp and support workpiece securely. ALWAYS
maintain proper control of saw. Failure to clamp and support workpiece and
loss of control of saw could result in serious injury.
USINGTHE
EDGE GUIDE (Fig. 16 and 16a)
i
i
WARNING;
ALWAYS unplug saw from the power source BEFORE
making any adjustments or attaching accessories,
1o Insert the bar of the edge guide through the slots in the base of the sabre saw
(see Fig. 16). The edge guide can be inserted from either side of the base, with the
guide edge facing down.
2, Screw the edge guide locking knob into the threaded hole in the base to tighten the
edge guide bar in place,,
3. Measure the distance from the edge of the workpiece to the line of cut. Slide the edge
guide to this desired distance and tighten the locking knob to secure edge guide in place
(Fig. 16a) and make your cut,,
Fig, 16a
I Z_ WAR N ING:
ALWAYS clamp and support workpiece securely. ALWAYS
I
maintain proper control of saw. Failure to clamp and support workpiece and
I
loss of control of saw could result In serious
injury,
19
t
t
1
I

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents