Description; Parts List - Craftsman 320.17234 Operator's Manual

PARTS LIST
(Fig. I)
loSaw
2. Two wood cutting blades
(stored in b_ade
storage compartment)
3. Edge Guide IIl
(stored in case)
(
4_ Vacuum Adapter 11!
(attached to saw)
5. Carry bag
KNOW YOUR SABRE SAW (Flgo2)
NOTE: Before attempting to use your saw, familiarize yourself with all of the
operating features and safety requirements.
Your sabre saw has a precision built electric motor and it should only be connected to a
120-volt, 60-Hz AC ONLY power supply (normal household current) DO NOT operate on
direct current (DC) This large voltage drop will cause a loss of power and the motor wiIf
overheat if the saw does not operate when plugged into a correct 120-volt, 60-Hz AC
ONLY outlet, check the power supply This saw has an 8-ft, 2-wire power cord (no adapter
needed)_
1
This Sabre Saw has the following features:
1 4.5 Amp, Variable Speed Motor, 800 to 3000 SPM strokes per minute
(no-load speed),
2, Variable Speed is controlled by the speed dial located on the top front of the trigger
switch handle.
3o Blade Guide Support Roller provides added blade control, 11/16 inch blade stroke
for smooth cutting.
4. Durable Epoxy Coated Steel Base glides smoothly over workpiece Bevel scaie for
easy adjustments,
5o Bevel Cutting Capacity 0 ° to 45° left and right.
6 Quick blade changes with no tools.
7o LED Worklight illuminates cutting area
8 "Live Tool indicator" Light is green when saw is plugged into power source
9, Extended Length Trigger Switch with Power Lock-On Button,
10. Clear Front Chip Shield/Blade Guard
11 Sawdust Removal: Vacuum adapter on bottom of saw attaches to 11/44nch adapter
and then to wet/dry vac (bath sold separately) for removal of sawdust and chips from
the cutting area
12. Includes Edge Guide, ideal for fast, straight repetitive cutting
I3. Permanently Lubricated 100% Ball Bearings for smooth operation, long life_
14. Includes Impact Resistant Case for easy carrying and storage.
11