RETAINER
SCREW
_T
ROPE
PULLEY
HOLE
SERVICE AND ADJUSTMENTS
RIB
RETAINER
"SCREW/POST
Figure 20
• Insert the end of the rope through the eyelet on the trig-
ger handle, then through the eyelet in the notch on the
engine shroud. Figure 21.
• Insert one end of the rope into the pulley and up
through the pulley hole. Figure 20.
• Leave a 1 inch (2.5cm) tail laying between the retainer
rib and the retainer screw post. Figure 20.
• Tighten the rope retainer screw until the bottom of the
rope retainer is snug.
• Hold the rope taut at the rope exit hole so the pulleywilt
not move. Remove the hex wrench and slowly feed the
rope into the pulley.
•
Follow steps for disassembly to reinstall.
PULLEY
NOTCH
Figure 21
EYELETS
Figure 22
-18-