Error Messages - Lenovo ThinkPad X200 Tablet Hardware Maintenance Manual

Table 2. Numeric error codes (continued)
Symptom or error
1830
Invalid memory configuration—Power off and install a
memory module to Slot-0 or the lower slot.
2000
Hard Drive Active Protection sensor diagnostics
failed.Press <Esc> to continue.Press <F1> to enter
SETUP
2010
Warning: Your internal hard disk drive (HDD) may not
function correctly on this system. Ensure that your HDD
is supported on this system and that the latest HDD
firmware is installed.
201x
The solid state drive you have installed has not passed
qualification for use in this computer. Using this drive may
cause compatibility issues and potential issues with data
integrity, including data loss. Press <Esc> to continue.
2100
Initialization error on HDD0 (Main hard disk drive)
2102
Initialization error on HDD1 (Ultrabay hard disk drive)
2110
Read error on HDD0 (Main hard disk drive)
2112
Read error on HDD1 (Ultrabay hard disk drive)

Error messages

Table 3. Error messages
Symptom or error
Device address conflict.
Allocation error for device.
FRU or action, in sequence
Install DIMM in Slot-0, but not in Slot-1.
Note: For the construction of the DIMM slot, see "1040
DIMM" on page 65.
1. Undock docking station or port replicator if it is
attached to the ThinkPad Notebook.
2. Place the ThinkPad Notebook on a horizontal surface.
Do not apply any physical shock to the computer.
3. Run Diagnostics ➙ ThinkPad Devices ➙ HDD
Active Protection Test.
Inform the following information to the customer: If
in the primary bay the customer is using a non-IBM
or non-Lenovo hard disk drive (HDD), or an old
generation IBM HDD which is not supported by this
system, with the risk in mind, the customer can still
use it by pressing ESC. If in the primary drive bay the
customer is using a supported IBM/Lenovo HDD with
an old firmware, the customer needs to update its
firmware to the latest. The latest version is available at
http://www.lenovo.com/support.
Inform the following information to the customer: If the
customer is using a non qualified SSD which is not
supported by this system, with the risk in mind, the
customer can still use it by pressing ESC. Location of the
SSD is designated as below:
2010: HDD0 (in HDD slot-0)
2011: HDD1 (in HDD slot-1)
2012: Ultrabay with HDD adapter
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay™ hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
FRU or action, in sequence
1. Load "Setup Defaults" in the BIOS Setup Utility.
2. Backup battery.
3. System board.
1. Load "Setup Defaults" in the BIOS Setup Utility.
2. Backup battery.
3. System board.
Chapter 4
.
Related service information
43